Heroes of Might and Magic 3 Castle Model Cetak 3D

Intended for 3d print.

The Castle town from Heroes of Might and Magic 3. This model pack includes both the whole castle as a single-piece model, and its constituent parts as separate models (towers, main gate, wall sections et cetera). The separate model parts CAN be used to build a custom castle with a different layout than the original castle, but this is not a very sophisticated model kit - depending on what kind of layout you decide to try, you may have to cut parts of the walls off prior to printing, to make the model parts fit together. So some basic knowledge of slicer software functions is recommended.

Detailed list
This model pack includes the following models:

• HoMM3 Castle
  
• Tall, round tower
  
• Squat, square tower
  
• Wall section
  
• Tall, round tower along a straight wall section (this model fits together with the ends of the Wall section model)
  
• Tall, round tower at the corner of two wall sections (this model fits together with the ends of the Wall section model)
  

Suggested scale
The models will lose some detail at smaller scales, but from a purely structural perspective they can be printed at 8mm scale or below without becoming too delicate. Just be aware that these models are not very detailed in the first place, and may look a bit primitive at 25mm scale and above. Siap Cetak: Tidak